From William Lee.

FLAME Heating, Cooling, Plumbing, Electrical
Flame installed a complete HVAC system (furnace, AC, and humidifier) in my home back in 2012, they replaced the old furnace which was 47 years old and the AC which was almost as old.
Flame installs Bryant HVAC systems and after some online research, I've decided to have a full Bryant HVAC system installed and I'm completely satisfied with the new level of comfort and energy savings I'm getting.
I'll start by saying that this was not cheap, it was very expensive, but you really get what you paid for, competent technicians and a company that stands behind the products they sell & install.
What I ended up with was a new 96% efficient furnace, a more efficient AC system, a really good and efficient (low water usage) humidifier, a new chimney flue liner for the hot water heater exhaust (the new furnace exhaust & intake is through the side of the house), and last but not least was the duct cleaning.
The install crew, Stephan, Bill and electrician Bill, were truly professionals and they did a tremendous job removing the old and installing the new, you can tell by looking at the details of the install like how the humidifier and AC condensate drain line is actually pitched properly to drain, how the intake and exhaust pipes were run parallel to the outside of the house, how the water feed line is routed to feed the humidifier, how the old water heater exhaust was upgraded to draft properly with the new chimney liner, small things like that shows that care was taken when it was installed. The crew showed up in the morning and was done with the install before 5 PM. I scheduled the duct cleaning 2 weeks later because of my personal schedule and the duct cleaning tech showed up on time and did a complete and thorough job.
As with any job this large in scope there were some problems to be hammered out. The service tech that came out to setup and check for proper operation of the furnace found a gas control valve that was plugged up with debris and was stopping the valve from going into high-burn, he ordered and picked up a new gas control valve at the local supply house and installed it. Unfortunately, that valve would not go into high-burn either.
The tech looked at the valve and saw debris/dirt at the inlet of the valve, he had to remove the newly installed gas piping to remove the clump of dried mud and bits of plastic from the inside of the pipe. Unfortunately the local supply house didn't have another gas control valve in stock and I had to wait a few day for the factory to ship one in. After the install of the new valve the furnace was set up and gave the proper combustion readings and I was good to go, no problems with the furnace since. As for the dried mud and plastic bits in the pipe, I'm guessing that it was in the pipe before it was cut and threaded because the pipe was clean and rust free when it was delivered to my house which tells me that it's a vendor QC problem.
Fast forward to late spring of 2017. The AC was working perfectly until now. I'm a Gold Plan member and I called for my annual AC inspection and I told the nice lady on the phone that my AC is not cooling and I'm getting fault warnings on my intelligent thermostat.
The inspection tech arrived on time and found that my AC evaporator coil (above the furnace) has a leak and needs to be replaced. It was a pleasant surprise to find that the leaking evaporator coil was covered under the Bryant warranty and it did not cost me anything for parts or labor.
As a Flame Gold Plan member they come out and inspect the AC in the late spring and inspect the furnace in the late fall. All in all, I happy with Flame.